Journal of Production Engineering

Lorem ipsum dolor sit amet, consectetur adipisicing elit, sed do eiusmod tempor incididunt ut ero labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco.

Search
GUIDE FOR AUTHORS SUBMIT MANUSCRIPT
Vol. 6 No. 5, 6 (1989): Former "Proceedings of the Institute of Production Engineering"
Original Research Article

Contribution to research after foundations for defining the conception of machining system modular design

FULL TEXT ARTICLE (PDF)
  • Jožef Rekecki,
  • Milan Zeljković,
  • Ljubomir Borojev,
  • Ratko Gatalo,
  • Janko Hodolič
Jožef Rekecki University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
Milan Zeljković University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
Ljubomir Borojev University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
Ratko Gatalo University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
Janko Hodolič University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia

Published 1989-12-01

Keywords

  • turning,
  • grinders,
  • drilling,
  • machining centers,
  • construction

Copyright (c) 2023 Journal of Production Engineering

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Abstract

The paper presents some results of research into the geometric and technological characteristics in the late construction of turning machines, grinders, drilling machines, and machining centers. This research forms the foundation for designing their primary characteristics and defining the concept of modular design. Despite this, the initial approach was that one of the most efficient methods for forecasting the technical characteristics of machining systems is trend extrapolation.

FULL TEXT ARTICLE (PDF)