Tooth contact analysis of a designed planetary gear drive for the vehicle industry

Authors

  • Sándor Bodzás Department of Mechanical Engineering, University of Debrecen, Debrecen, Ótemető str. 2-4, 4028, Hungary
  • Zsolt Békési University of Debrecen, Department of Air- and Load Vehicle
  • József Kertész University of Debrecen, Department of Air- and Load Vehicle
  • Tamás Szorcsik TRIGON Electronica Ltd., Salgótarján, Hungary

DOI:

https://doi.org/10.24867/JPE-2021-02-020

Keywords:

Planetary gear drive, CAD, TCA, normal stress, normal deformation, analysis

Abstract

A planetary gear drive consists of a sun gear, planet pinions and an internal gear. We designed a complex gear system which is usable in the field of the vehicle industry into the automatized robots. The system was designed by GearTeq software which is connected with the SolidWorks designer software. After the assembly and the motion simulations tooth contact analysis (TCA) was made to analyse the normal stresses and the normal deformations on the connecting surface of the planet pinions and the internal gear by different load moments.

Downloads

Published

2023-10-11

Issue

Vol. 24 No. 2 (2021)

Section

Original Research Article

License

Copyright (c) 2023 Journal of Production Engineering

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

Tooth contact analysis of a designed planetary gear drive for the vehicle industry. (2023). Journal of Production Engineering, 24(2), 20-26. https://doi.org/10.24867/JPE-2021-02-020