FEM analysis of the tooth of pinions in case of bevel gears having the modification of the shaft angles by the changing of load forces

Authors

  • Sándor Bodzás Department of Mechanical Engineering, University of Debrecen, Debrecen, Ótemető str. 2-4, 4028, Hungary

DOI:

https://doi.org/10.24867/JPE-2022-01-005

Keywords:

Tooth, bevel gear, load force, FEM, normal, pitch angle

Abstract

Five types of bevel gears having different shaft angles were designed. In this publication the analysis of the tooth of pinions will be focused. Different load forces will be loaded on the top of the tooth on the surfaces of the face cones. The normal stresses and normal deformations of one tooth will be analysed into two perpendicular directions on both tooth sides. The aim is the foundation of the correlation between the mechanical parameters and the shaft angles by the different load forces.

Downloads

Published

2022-06-30

Issue

Vol. 25 No. 1 (2022)

Section

Original Research Article

License

Copyright (c) 2023 Journal of Production Engineering

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

FEM analysis of the tooth of pinions in case of bevel gears having the modification of the shaft angles by the changing of load forces. (2022). Journal of Production Engineering, 25(1), 5-14. https://doi.org/10.24867/JPE-2022-01-005