Stress-strain state of I-beam due to fillet welding

Authors

  • Sabo Bela University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia

DOI:

https://doi.org/10.24867/JPE-1985-02-085

Keywords:

stress, I-beam, welding, deformation

Abstract

This article describes the stress-strain state of an I-beam as a result of fillet welding. It provides an overview of total plastic and elastic longitudinal welding deformations and longitudinal welding stresses. The welding deformations are measured at ten measuring points using mechanical strain gauges with the utilization of extracted measuring sections.

Downloads

Published

1985-12-01

Issue

Vol. 2 No. 2 (1985): Former "Proceedings of the Institute of Production Engineering"

Section

Original Research Article

License

Copyright (c) 2023 Journal of Production Engineering

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

Stress-strain state of I-beam due to fillet welding . (1985). Journal of Production Engineering, 2(2), 85-96. https://doi.org/10.24867/JPE-1985-02-085