Exploring response surface of cutting forces for an end milling cutter

Authors

  • Pavel Kovač University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia

DOI:

https://doi.org/10.24867/JPE-1984-01-073

Keywords:

milling, cutting force, feed, depth of cut, cutting speed

Abstract

This paper deals with the fundamental determina­tion of cutting forces in face milling, describes the measure equipment and computer use Some results including the variation of cutting forces with feed, speed and depth of cut are presented.

Downloads

Published

1984-12-12

Issue

Vol. 1, No. 1 (1984) (Former "Proceedings of the Institute of Production Engineering")

Section

Original Research Article

License

Copyright (c) 2023 Journal of Production Engineering

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

Exploring response surface of cutting forces for an end milling cutter. (1984). Journal of Production Engineering, 1(1), 73-84. https://doi.org/10.24867/JPE-1984-01-073