Journal of Production Engineering

 

Search
GUIDE FOR AUTHORS SUBMIT MANUSCRIPT
Vol. 22 No. 1 (2019)
Original Research Article

The correlation of tool wear parameters with machining process parameters

FULL TEXT ARTICLE (PDF)
  • Pavel Kovač,
  • Borislav Savković,
  • Dragan Rodić,
  • Dušan Ješić
Pavel Kovač University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
Borislav Savković University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
Dragan Rodić University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
Dušan Ješić

DOI

Published 2023-11-18

Keywords

  • cutting temperature,
  • cutting forces,
  • surface roughness,
  • tool wear parameters

Copyright (c) 2023 Journal of Production Engineering

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Abstract

The paper delineates correlations established between tool wear parameters and the machinability parameters in face milling processes: cutting temperature, cutting forces, and surface roughness, as per concurrent measurements. The systematic arrangement of measurements facilitated the simultaneous tracking of the progress of all scrutinized parameters concerning cutting time until tool wear occurred under specific cutting conditions. This organized approach allowed for the modeling of correlations among these parameters, aiding in understanding their interdependencies and effects on the machining process.

FULL TEXT ARTICLE (PDF)