Contribution to development of software system for  the automated design gears

Dragoljub Novaković; Ratko Gatalo; Jožef Rekecki; Slobodan Navalušić

doi:10.24867/JPE-1989-06-241

Vol. 6 No. 5, 6 (1989): Former "Proceedings of the Institute of Production Engineering"

Original Research Article

Contribution to development of software system for the automated design gears

FULL TEXT ARTICLE (PDF)

Dragoljub Novaković,
Ratko Gatalo,
Jožef Rekecki,
Slobodan Navalušić

more info

Dragoljub Novaković
University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia

Ratko Gatalo
University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia

Jožef Rekecki
University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia

Slobodan Navalušić
University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia

DOI: https://doi.org/10.24867/JPE-1989-06-241

Published 1989-12-01

abstract views: 6 // FULL TEXT ARTICLE (PDF): 4

Keywords

software system,
calculating and verifying stress

How to Cite

Novaković, Dragoljub, Ratko Gatalo, Jožef Rekecki, and Slobodan Navalušić. 1989. “Contribution to Development of Software System for the Automated Design Gears”. Journal of Production Engineering 6 (5, 6):241-54. https://doi.org/10.24867/JPE-1989-06-241.

This work is licensed under a Creative Commons Attribution 4.0 International License.

Abstract

The results presented in this paper are a part of the software system for calculating and verifying stress and producing all the documentation for gears. The paper describes the starting design logic and methodology, which utilize optimal values of relevant factors to provide designers with all the elements necessary to define the gear. The calculated values enable the designer to create gears with the maximum degree of safety against bending, stress, and wear. Additionally, the software, based on these calculated values, designs and generates drawings for the gears. This paper specifically showcases the software for the first phase, which is the calculation and verification of gears with straight and helical teeth.

PlumX Metrics

Dimensions Citation Metrics