Journal of Production Engineering

Lorem ipsum dolor sit amet, consectetur adipisicing elit, sed do eiusmod tempor incididunt ut ero labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco.

Search
GUIDE FOR AUTHORS SUBMIT MANUSCRIPT
Vol. 21 No. 2 (2018)
Original Research Article

Optimization of the process parameters for stabilization and improvement of the turning process capability

FULL TEXT ARTICLE (PDF)
  • Luka Cerce,
  • Davorin Kramar,
  • Stevo Borojević
Luka Cerce
University of Ljubljana, Faculty of Mechanical Engineering, Department of Machining Technology Management, Aškerčeva 6, 1000 Ljubljana, Slovenia
Davorin Kramar
University of Ljubljana, Faculty of Mechanical Engineering, Department of Machining Technology Management, Aškerčeva 6, 1000 Ljubljana, Slovenia
Stevo Borojević
University of Banja Luka, Faculty of Mechanical Engineering, Stepe Stepanovića 75, 78000 Banja Luka, Bosnia and Herzegovina
DOI: https://doi.org/10.24867/JPE-2018-02-006

Published 2018-12-30

abstract views: 16 // FULL TEXT ARTICLE (PDF): 13


Keywords

  • Roundness,
  • MSA,
  • SPC,
  • DOE

How to Cite

Cerce, Luka, Davorin Kramar, and Stevo Borojević. 2018. “Optimization of the Process Parameters for Stabilization and Improvement of the Turning Process Capability”. Journal of Production Engineering 21 (2):7-12. https://doi.org/10.24867/JPE-2018-02-006.

Copyright (c) 2023 Journal of Production Engineering

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Abstract

The paper deals with a narrow tolerances turning process. A statistical process control (SPC) on the existent machining process showed that the process was not stable and incapable. Before the machining process analysis a measurement system analysis (MSA) of the applied measuring system has been performed. In order to stabilize the process the machine tool linear axis calibration has been performed. The stability and capability of the machining process increased but the problem of the roundness was still present. The possible process parameters, which could affect the roundness, were examined with the design of the experiment methodology (DOE). The results showed that the clamping force has the largest effect. Therefor a new clamping fixture was suggested to eliminate the roundness problem.

PlumX Metrics

Dimensions Citation Metrics

FULL TEXT ARTICLE (PDF)