Journal of Production Engineering

Lorem ipsum dolor sit amet, consectetur adipisicing elit, sed do eiusmod tempor incididunt ut ero labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco.

Search
GUIDE FOR AUTHORS SUBMIT MANUSCRIPT
Vol. 22 No. 2 (2019)
Original Research Article

Tribology study of aluminum-based foam

FULL TEXT ARTICLE (PDF)
  • Nikola Palic,
  • Varun Sharma,
  • Fatima Zivic,
  • Slobodan Mitrovic,
  • Nenad Grujovic
Nikola Palic
University of Kragujevac, Faculty of Engineering, Kragujevac, Sestre Janjic 6, 34000 Kragujevac, Serbia
Fatima Zivic
University of Kragujevac, Faculty of Engineering, Kragujevac, Sestre Janjic 6, 34000 Kragujevac, Serbia
Slobodan Mitrovic
University of Kragujevac, Faculty of Engineering, Kragujevac, Sestre Janjic 6, 34000 Kragujevac, Serbia
Nenad Grujovic
University of Kragujevac, Faculty of Engineering, Kragujevac, Sestre Janjic 6, 34000 Kragujevac, Serbia
DOI: https://doi.org/10.24867/JPE-2019-02-001

Published 2019-12-30

abstract views: 32 // FULL TEXT ARTICLE (PDF): 19


Keywords

  • Porous structures,
  • Closed – cell Al-based foam,
  • Dynamic Friction coefficient

How to Cite

Palic, Nikola, Varun Sharma, Fatima Zivic, Slobodan Mitrovic, and Nenad Grujovic. 2019. “Tribology Study of Aluminum-Based Foam”. Journal of Production Engineering 22 (2):1-4. https://doi.org/10.24867/JPE-2019-02-001.

Copyright (c) 2023 Journal of Production Engineering

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Abstract

Closed cell metallic foam prepared from ALUHAB technology has been studied using tribological methodology. The main goal of the study was tribological properties of closed cell porous structure made of aluminium alloy. Tribological testing of the porous Al-based alloy were realised under different low loads: 10 mN, 25 mN, 50 mN, 75 mN, and 100 mN using CSM nanotribometer, with linear reciprocating mode. Ball-on-disc contact geometry was used and dynamic friction coefficient was observed. Results revealed that, friction coefficient exhibited large fluctuations in values under different loads, from moderate friction coefficient (0.2 at 100 mN load) up to the very high values (1.4 at 25 mN load). Under very small loads (10 mN) it was hard to get reliable results due to porosity influence and extremely high friction coefficient values were obtained.

PlumX Metrics

Dimensions Citation Metrics

FULL TEXT ARTICLE (PDF)